Наверное это - или по такому принципу выбирать(надежда есть на European sizes)):
Fold Selection and Editing (Assign folds, Assign handfeeds)
Accessible to the Key Operator and technician
These functions allow the Key Operator to add/delete fold programs, and to modify bookfold binding margins, etc.
Although there are approximately 70 different fold programs stored in the folder firmware, a given
user will be interested in only a few of them. The most popular programs have been collected into
groups, called Fold Banks, each containing up to 10 programs, see Section 9. The programs
included in each Fold Bank are targeted to the local conventions of a specific geographic market.
Select the appropriate Fold Bank number from the Parameters list under the System Menu. This
action loads the set of programs contained in the Fold Bank to NVRAM, which in turn provides a
program list to the operator’s control panel, and also makes the same list available to the Host
Controller. NOTE: This action loads the handfeed menu as well as the on-line folding menu. Fold
banks can only be changed by the technician.
Once the Fold Bank has been selected, the NVRAM program list available at the operator’s
control panel and the host controller may be edited. This allows programs to be added, or deleted
by the Key Operator to simplify the selections available to the user. But note that the Fold Bank
itself is in firmware and cannot be changed. Editing is confined to the list in NVRAM.
To edit the operator’s program list, select Assign Folds from the SYSTEM MENU. The control panel
displays:
Fold Menu: #2
Fold Table: Number
Description
1: Change 4: Quit
NOTE: “Table” = Program number in the folder firmware, see Section 9.
The #2 menu selection is the first one available for editing because the first selection is always
STACK, which cannot be changed. To change or delete the selection press 1. The control panel
displays:
1: Set By Fold Table #
2: Choose from List
3: Remove from Menu
4: Quit
If you do not know the “table” (fold program), or do not have Section 9 available, press the 2
button to enter the list, then scroll through to select (press 1 to “Add”). To delete the current fold
program from the Fold Bank, press the 3 button (this does not erase the program from the
firmware). Press 4 to return to the previous display.
The maximum number of fold programs that can be included in the operator’s program list
(NVRAM) is 20.
FOLD BANK 1 (common European sizes)
Position Fold Table Display Description
1 0 STACK No fold, flat sheet stack on top of folder cabinet
2 47 DIN 824 TYPE A Bookfold Style 1 (F = Favors Front), 190mm panels, 20mm binding margin, Z crossfold
3 43 DIN 824 TYPE B Bookfold Style 1 (F = Favors Front), 190mm panels, 0mm binding margin, tab, Z crossfold 297mm
4 44 DIN 824 TYPE C Endless fold style 210mm panels, Z crossfold 297mm
5 46 210 x 297 BkF Z 0mm
Bookfold Style 1 (F = Favors Front), 210mm panels, 0mm binding margin, Z crossfold
6 53 ERICSSON Special fold program to Ericsson specification
7 56 210 FANFOLD 210mm panels, accordion fold only
8 57 297 FANFOLD 297mm panels, accordion fold only