2.4.43 C-0213
Code
C-0213
Classification
Main body: Paper exit abnormality
Cause
Within a specified period of time after the paper exit pressure home sensor (PS28) becomes inactive, it does not become active.
Measures to take when an alert occurs
The main body and the option stop immediately to deactivate the main relay.
Estimated abnormal parts
• Conveyance drive board (CDB)
• Printer control board (PRCB)
• Exit motor (M30)
• Paper exit pressure home sensor (PS28)
Correction
Note
▪ The message "Please call service" is displayed on the panel.
Solution
1. Check the de-curler unit, and clean or repair it when there is any abnormality.
2. Check the paper exit drive gear system, and clean or repair it when there is any abnormality.
3. Check the connector connection and the wiring between PRCB and PS28, and repair it when there is any abnormality.5. Check the connector connection and the wiring between CDB and PRCB, and repair it when there is any abnormality.
6. Check IO Check (86-18) and others and the operation of PS28, and repair or replace it when there is any abnormality. (Wiring diagram:
Main body (1/4):22-K)
7. Check IO Check (27-20) and others of M30 or the coupling of the gear, and repair or replace it when there is any abnormality. (Wiring
diagram: Main body (1/4): 24-K)
8. Replace PS28.
9. Replace M30.
10. Replace CDB. (CONNECTOR LAYOUT DRAWING IN BOARD: L.2.1.7 Conveyance drive board)
11. Replace PRCB. (CONNECTOR LAYOUT DRAWING IN BOARD: L.2.1.2 Printer control board)
12. Replace M30 and CDB at a time. (CONNECTOR LAYOUT DRAWING IN BOARD: L.2.1.7 Conveyance drive board)
Faulty part isolation DIPSW
Control during the detachment