Цитата:
Сообщение от trid
мануал есть, все делали по нему вроде
|
там же написано решение:
Solution
1. Check that the process unit is correctly installed without looseness, and reinstall/repair it if any abnormality.
2. Check the installation of developing unit and I/O, and repair/replace it if any abnormality.
3. Check the connector connection and the wiring between PRCB and IDCS, and repair it if any abnormality.
4. Check the I/O of SD3 and repair/replace it if any abnormality.
5. Check the sensor, and clean/repair it if any dirt or abnormality. (Wiring diagram: Main body (3/3): 5-P)
6. Replace IDCS.
7. Replacing the developing unit
8. Replace PRCB.
одно из них верное должно быть...